Connect your DJI Spark to a remote controller

When you first receive your DJI Spark, your remote control and drone will already be paired out of the box, but if you purchase a remote control separately or if your remote control isn’t paired, here is a step-by-step guide to help you.

Before you begin, make sure both are fully charged.

1. Turn on your DJI Spark and the remote controller.
2. If the status LED on the controller is red, it still needs to be paired with the drone.
3. Press and hold the “Power” button for three seconds until the drone beeps and the front LEDs begin to slowly flash red.
4. On the Controller, press and hold these three buttons at the same time: the Pause button, the Function button, and the Customize button.
5. When the LED on the Controller is green, the pairing was successful.
6. Now connect your smartphone or tablet to the remote controller, open the Wi-Fi settings on your smartphone or tablet, and connect to the SSID listed on the bottom of your remote controller: “Spark-RC-XXXXXX.”
7. Now open your DJI Go 4 app and tap “Start Flight.”

 

Note: If you only want to connect your drone to your smartphone or tablet—that is, without a remote controller—simply press and hold the Power button on the DJI Spark for 6 seconds, then connect to it through your smartphone or tablet’s Wi-Fi settings. Use the Wi-Fi code and password listed on your drone just below the Batterij or on the side of the box your drone came in when you purchased it.