DJI Mavic Mini Firmware Update

Overview of the New DJI Mavic Mini Firmware Update

• Date: December 31, 2019
• Aircraft Firmware: v01.00.0400
• Remote Controller: v01.00.0400
• DJI Fly App for iOS: V1.0.4
• DJI Fly App for Android: V1.0.4

What’s the news?

• New feature added: unlock GEO zones (DJI Fly v1.0.4 or later).
• New feature added: Takeoff is not possible if the GPS signal is too weak ( <, 8 visible satellites) or if there is insufficient ambient light (for the limited number of sensors). You can manually disable this feature (in DJI Fly v1.0.4 or later).
• Requirement added: If there is insufficient ambient light for the sensors, you must first perform a compass calibration, as the compass is experiencing ambient interference.
• Adjusted flight altitude and distance in payload mode.
• Added a warning about the number of times you’ve used the Batterij.
• Less noise during startup and its self-test procedure.
• Resolved issue: Your drone did not always pair with the RC in certain regions.

Note:

• Please note that the update may reset various settings on your remote control—such as the RTH altitude and maximum flight distance—to their default values. Make a note of your settings before performing the update so you can restore them afterward. It’s also a good idea to always check these settings right before each flight.
• If the update fails, wait long enough, then completely restart the drone, the Remote control, and the DJI Fly software, and try again.

dronedepot.live is not responsible for the content of these recommendations. The content of this article was provided by DJI itself.